Reef dosing calculator
Use net water: tank plus sump, minus rock and sand.
Where the numbers come from
Red Sea prints its Foundation figures for 100 litres. One millilitre of Foundation A raises calcium by 2 ppm, one millilitre of liquid Foundation B raises alkalinity by 0.1 dKH, and one millilitre of Foundation C raises magnesium by 1 ppm. The calculator scales those to your volume. For calcium that means ml = ppm wanted × litres ÷ 200.
The Foundation powders have their own figures. Red Sea states that 1 g of Foundation A powder raises calcium in 100 litres by 3.6 ppm, 1 g of Foundation B powder raises alkalinity by 0.33 dKH, and 1 g of Foundation C powder raises magnesium by 1.34 ppm. For alkalinity that works out to grams = dKH wanted × litres ÷ 33.
Seachem prints its figures per dose of powder. Reef Advantage Calcium raises calcium by about 12 mg/L for each 5 g in 150 litres. Reef Advantage Magnesium raises magnesium by about 5 mg/L for each 5 g in 80 litres. Reef Builder raises alkalinity by about 0.25 meq/L for each 3 g in 150 litres, which is about 0.7 dKH. The calculator turns each of those into grams for your tank.
Liquids come out in millilitres and powders in grams. Do not swap one for the other, because a millilitre of liquid and a gram of powder do not raise a parameter by the same amount. The same goes for Red Sea’s stock solutions: its manual gives a separate table for powder you have already dissolved in RO water, and those per-millilitre figures are not the per-gram figures above.
Red Sea says to add its supplements to the sump. With no sump, add them slowly in an area of high flow, away from fish and corals.
Worked examples for a 200 litre system
| Change | Red Sea liquid | Red Sea powder | Seachem powder | Days at the ceiling |
|---|---|---|---|---|
| Calcium up 30 ppm | 30 ml of A | 16.7 g of A | 16.7 g Reef Advantage Calcium | 2 |
| Alkalinity up 1 dKH | 20 ml of B | 6.1 g of B | 5.7 g Reef Builder | 1 |
| Magnesium up 50 ppm | 100 ml of C | 74.6 g of C | 125 g Reef Advantage Magnesium | 5 |
The totals scale with volume. A 400 litre system needs twice as much for the same change, and a 100 litre nano needs half.
The daily ceiling
Red Sea states how far you should push each parameter in a day: calcium by 20 ppm, alkalinity by 0.5 meq/L (1.4 dKH) and magnesium by 10 ppm. The calculator uses those three numbers for both brands and divides a bigger correction into days. Seachem states its own cap for magnesium, 25 g per 80 litres a day, which is a rise of 25 mg/L. The calculator uses the lower Red Sea figure for both brands, which keeps every correction on the cautious side.
Red Sea also gives an order when you dose more than one parameter on the same day: magnesium first, alkalinity second, calcium third, ten minutes apart. Add each one where the flow is strong so it mixes quickly.
If your gap is large, plan on several days of small steps. A swing from 7 dKH to 11 dKH is a rise of 4 dKH, which is three days at the 1.4 dKH ceiling, and the calculator will tell you so. Keep a short log of the date, the reading and the dose. After a week it shows how fast your own tank uses each parameter, and that rate is what the next dose should be built around.
Seachem gives 380 to 420 mg/L as the calcium range for its Reef Advantage Calcium. Pick a target for your own system and keep it steady. If you decide to change the target, move it a little at a time and record each new figure in your log.
Test before you dose
The calculator starts from your test result, so a wrong reading gives a wrong dose. Pick a kit you can read consistently and use it the same way each time. The reef test kit buying guide compares the kit types. The Salifert calcium, KH alkalinity and magnesium kits cover the three numbers in the calculator. Red Sea makes a Foundation Pro multi test kit for use with its Foundation range.
We test with a Neptune Trident and cross-check it once a month against Salifert and Red Sea test kits. If the kits disagree by a wide margin, test again before you dose.
The mistake beginners make most often is chasing absolute numbers. A reading a few points off the target is not an emergency, and a big dose to close the gap overshoots as easily as it corrects. Watch which way the numbers move from one test to the next, and use the calculator to correct a real gap.
For a plain explanation of what each parameter does, see the KH and alkalinity page and the calcium and magnesium page. Alkalinity is quoted in dKH here, and one meq/L is 2.8 dKH, so a kit that reads in meq/L needs converting before you type it in.
Why the readings do not always move as predicted
The calculator gives the dose that the maker says should change a clean tank by the amount you asked for. Real tanks consume. Corals and coralline algae pull calcium and alkalinity out of the water as they grow, so a dose that looks right on paper can land lower after a few days. That is the reason for the 48 hour re-test.
Salinity matters too. Red Sea notes that a rise of 1 ppt in salinity adds roughly 13 ppm of calcium and 40 ppm of magnesium. A water change with fresh salt mix, or topping up with salt water in place of fresh, moves those numbers without any additive. If a reading jumps for no reason, test your salinity before you test anything else.
Evaporation concentrates everything. Top up with fresh RO water so the salinity stays put and the correction you calculated stays valid. Our water volume calculator gives you the litres figure to start from if you are unsure what your system really holds.
Dosing by hand or by pump
Hand dosing suits a small or lightly stocked reef where the numbers drift slowly. Heavy coral growth uses calcium and alkalinity quickly enough that a daily hand dose becomes a chore, and that is where a controller and dosing pumps start to pay off. We dose Red Sea additives with a Red Sea Doser. Dosing should follow what the tank consumes each day, so the parameters stay stable, and we spread the schedule through the day instead of dosing once.
The calculator still helps on a pump. It tells you how much the system must add in a day to correct a gap, which you can compare with the total your pump is programmed to deliver.
What the calculator leaves out
Only products with a maker-stated rise are in it. Korallen-Zucht publishes a maximum daily dose for its Calcium Plus and KH Plus liquids, for instance 1 ml per 25 gallons, but no figure for how much that moves a reading, so we do not convert it. Red Sea Foundation ABC+, reactor media and kalkwasser are also outside it, as each works on a different footing. When you use one of those, follow the maker’s dosing sheet and test after every step.
The output is a starting dose. Test again after it, and compare that reading with the one you started from.
Common questions
Can I dose calcium and alkalinity on the same day? Red Sea’s order is magnesium first, alkalinity second and calcium third, ten minutes apart, which covers dosing several on one day. Use separate pours and keep the flow strong where you add them.
What if my target is only a few points above my reading? Then the dose is small and fits in one go. The calculator shows a single dose whenever the rise is inside the daily ceiling.
Does the volume include the sump? Yes. Use the water in the tank and sump together, minus the space taken by rock and sand. If you are unsure, use a slightly lower number so the dose errs small.
Why are the powder answers in grams? Seachem and Red Sea both print the rise per gram of powder, so grams is the unit their figures support. A scoop is not a gram, so weigh the powder on a small scale.
Related calculators and guides
- Aquarium and reef test kits buying guide
- Water volume calculator for tank and sump, to get the litres figure used above
- All aquarium calculators






